I am trying to setup advanced alerts for hardware health monitoring. I am not sure if I am seeing correct behavior.
For this example, I have a server that I know has a battery with low voltage - the 3.3V sensor is reporting back ~2,5v,
I have added a custom node poller, and a transform. I have added a summary chart and radial gauge, which work fine.
Now I try to add an alert, to post an alert when the value in the custom node poller goes below 2.8v. For this node, that case is always true.
I get the alert once, right after I create it, and never get another occurrence. If this correct behavior? I was expecting repeated alerts until the condition is cleared.