I currently have a UnDP setup to monitor OID: 1.3.6.1.4.1.9.9.147.1.2.1.1.1.4
This is displayed on my node details page and looks like this:
However here is my first issue:
1) The above image was pulled from my device named pix-primary, this device I know for a fact is running as the standby pix as this has already failed over to pix-secondary. So in reading the OID output above it is telling me that "(this device)" is the Active unit, this is untrue as this PIX has already failed over to the secondary and pix-primary should be the standby unit now. Or am I reading this wrong?
2) If I setup an alert to email me when the status changes how would I setup the reset trigger? So status changes and an alert is sent, when the status changes back that too is a status change, so this alert will always trigger and never reset. Is that correct?